時控開關的定時設置步驟如下：
The timing setting steps of the time control switch are as follows:
1、 按[定時]鍵 進入第1組定時開的設定（顯示1開）；
1, press the timing button to enter the first set timing setting (display 1 open).
2 、分別按[星期]、[時]、[分]鍵 設定開啟的時間（星期、時、分）；
2, set the opening time (week, hour, minute) according to the key of [week], [time], and [divide] respectively.
3 、再按[定時]鍵 進入第1組定時關的設定（顯示1關）；
3. Press the timer button to enter the first set timing setting (showing 1 passes).
4 、分別按[星期]、[時]、[分]鍵 設定關的時間（星期、時、分）；
4. Set the time (weeks, hours, minutes) separately according to the time of [week], [time], and [key].
5 、重復“1、2、3、4”步驟 可設定2-10組開關的時間；
5, repeat the steps of "1, 2, 3, 4" to set 2-10 groups of switches.
6、 連續按[定時]鍵 檢查各組開關時間和星期是否與要求的一樣，如不正確，還應重復步驟2、4；
6. Check the switch time and whether the week is the same as required by continuous time key. If incorrect, repeat steps 2 and 4 should be repeated.
7 、按[自動/手動]鍵 將開關符合（“ ▼ ”）調到當前時間所處的狀態（“開”或“關”）再調回到“自動”位置；
7. Switch the switch conforming to the current state ("open" or "turn") back to the "automatic" position according to the [automatic / manual] key.
8 、按[時鐘]鍵 結束時間設定進入時鐘顯示狀態。
8, press the "clock" key end time to enter the clock display status.