太陽能路燈控制器是路燈的“控制中心”，所有的線都匯聚于此，初次接線的時候一般都按先光源，然后蓄電池，最后電池板的接線順序。
先將燈具、蓄電池、電池板所有的正極匯集到一起然后接在控制器的+號所對應的那根線上。
然后把光源的負極接到控制器上燈泡負極所對應的那根線上。
之后把蓄電池的負極接到控制器上蓄電池負極所對應的那根線上，此時光源會亮起來，表明光源和蓄電池都已正常工作。
再后將電池板的負極接到控制器上電池板負極所對應的那根線上，過一會，光源會自動熄滅（因?yàn)楫?dāng)電池板負極接上以后，整套系統就通了，太陽能電池板產生電壓，控制器會自動由放電狀態轉為充電狀態），這表明電池板也成功接好，系統正常工作了。
最后將電線整理好，確保所有接頭用絕緣膠布裹好，并在外面包一層防水膠布，最后把控制器和線放進燈桿內，固定好，并關好門子。
The solar street lamp controller is the "control center" of the street lamp. All wires converge here. The initial wiring is generally in the order of light source, battery and battery panel.
First gather all the positive poles of lamps, batteries and battery boards together, and then connect them to the line corresponding to the + sign of the controller.
Then connect the negative pole of the light source to the line corresponding to the negative pole of the bulb on the controller.
Then connect the negative pole of the battery to the line corresponding to the negative pole of the battery on the controller. At this time, the light source will light up, indicating that both the light source and the battery have worked normally.
Then connect the negative pole of the battery panel to the line corresponding to the negative pole of the battery panel on the controller. After a while, the light source will automatically go out (because when the negative pole of the battery panel is connected, the whole system will be connected, the solar panel will generate voltage, and the controller will automatically change from discharge state to charging state), which indicates that the battery panel is also successfully connected and the system works normally.
Finally, arrange the wires, ensure that all joints are wrapped with insulating tape, and wrap a layer of waterproof tape on the outside. Finally, put the controller and wire into the lamp pole, fix it, and close the door.
